|
|
 |
| Components: Pin Wheel Split Bottom Mount |
|
This mount is basically like the "Pull-over Split Bottom" mount. Only difference is you let it do a couple of rotations before you go into the "Split Bottom" mount. |
It basically starts out with a "Pullover." You drape the string over your thumbnail (it doesn't burn when you pull if you put it over your thumbnail) and pinch it.
|
Pull the string down and at an angle. This causes the yo-yo to travel up.
|
Let go around and around your left thumb and index finger.
|
After going around several times you proceed into the "Split Bottom" stuff.
|
 
 
 
|
As the yo-yo swings around your left index finger, stick your right index finger out.
|
 
 
 
|
Your right index finger should make contact with the string about 2 inches above the yo-yo. |
 
 
|
The yo-yo will swing up and over your right index finger and land on the string as shown.
You've just complete what is known as the "split bottom entry" mount.
|
|
|
|
